WM Plastics Ink (fka TS Ink)
-
Base Just So Soft (fka WBF Base)
WM Plastics
Visit product page →WM Plastics Base Just So Soft (fka Waterbase Feel Base (WBF)) mimics the feel of waterbase inks, giving plastisol inks an extremely soft hand and a lighter feel.
Item #I10-1044
(fka 25-4401)
-
WM Plastics
Visit product page →WM Plastics Curable Reducer is an additive used for reducing the viscosity of ink without effecting the inks ability to cure. To acheive effect up to 15% can be used.
Item #I10-9906-A
(fka 25-6099)
View Info Sheet -
WM Plastics
Visit product page →Gloss & Stretch (G&S) base is a multi-use base that can be used as a stretch additive, glitter base, foil adhesive, underlay for stretch, and can be used with a Pigment Concentrate (PC) system (max load up to 15%).
Item I10-1020
(FKA Item: 25-0201)
As a stretch additive add up to 50% by weight.
Fusion/Curing: 325 F/163 C for 1 to 1 ½ minutes. Oven temperature can be increased and dwell time decreased. For heat presses use 390 F/195 C for 8 seconds.
View Info Sheet -
Long Life Nylon Bonding Additive
WM Plastics
Visit product page →WM Plastics Long Life Nylon Additive helps inks fuse to the tighter weave of nylon.
Use: 10-15% by weight. Cross linking/bonding continues after the substrate has passed through the oven. Full bonding to the substrate’s surface takes up to 72 hours. Do not scratch test immediately after printing
View Info Sheet -
WM Plastics
Visit product page →WM Plastics Puff Additive Creates a puff ink. Surface is rougher than a suede puff. Use 10%-15% additive
Item: I10-9903
View Info Sheet -
WM Plastics
Visit product page →WM Plastics Soft Hand Clear Base is a clear body base used to extend colors printed on lighter colored garments.
Item #I10-0111
(fka 25-1110)
Cures: 325ºF/160ºC for 1 to 1 ½ minutes. Oven temperature can be increased and dwell time decreased. For heat presses use 390ºF/195ºC for 8 seconds.
View Info Sheet
